When the Taipower P88 first came out, I bought one because it was relatively cheap and had a good reputation. After owning it, you really start to understand it, its exquisite appearance design and ingenious craftsmanship. The most surprising thing is its ultra-thin body design, even thinner than an iPad, which is top-notch. It's been a while since I started using it, and the system felt a little stuck. I planned to upgrade the system, so I went online to find some information about upgrading, and shared it with friends in need.

Preparations before upgrading

 To back up tablet data, you can use management software to back up with one click, such as Wandoujia. The main reason is that you don’t want to reinstall the software one by one after flashing. And the built-in SD card (called NAND FLASH in the system) will be formatted when flashing, so be sure to make a backup. 2. Secondly, make sure to flash the phone when the battery is sufficient.

Upgrade begins

Download first Unzip the upgrade package for the corresponding model of the tablet. There are many upgrade packages online, and there are many resources on Du Niang;

After the tablet is shut down. Press and hold the "M key", that is, "Volume +", and connect the tablet to the computer, preferably the USB port on the back of the motherboard, and let go after the computer prompts that new hardware has been found;

Manually specify the driver location to the corresponding folder in the "Driver" in the unzipped upgrade package. If it is a 32-bit system, enter the "X86" folder, select the corresponding operating system, and wait for the driver installation to complete. Make sure the driver installation is complete;

The method is to right-click the "My Computer" icon on the desktop, select "Manage", and then select "Device Manager". Check whether there is any content. If not, please re-execute the above two steps;

It may be that the device is imperfect. After the driver is installed first, it will "Device Manager" displays an exclamation mark, and the flash upgrade cannot be started at this time. At this time, you only need to disconnect the tablet from the computer, and press and hold the "M key" again, that is, "Volume +", to connect the tablet. Computer. At this time, you can see that the driver has been installed;

Run the "upgrade program" and you can see that the device has been connected. Select the corresponding upgrade file. ""Start the flash upgrade, please wait patiently. Remember not to move the tablet and computer during the flash upgrade process, do not disconnect, do not shut down and restart the computer, just watch blankly;

After the flash upgrade is completed, use a small pin to press the reset button. Wait for a few seconds. A robot interface will appear. After a few seconds, it will automatically restart. The entire flash upgrade process is over. The initial startup is slow, please Wait patiently.

As a Taipower p88 priced below a thousand yuan, It is indeed a very cost-effective tablet computer. I once regretted choosing the low-priced Teclast P88 instead of buying an Apple iPad. But after using the P88, I was gradually convinced by it. It's fascinating. Moreover, Taipower is very good at updating system files and optimizing the system on a regular basis. Personally, I think this is not much worse than the iPad. Another point is its simple integrated and streamlined ultra-wave body design. Fascinating, the ergonomic hand design makes it feel just right in the hand and can be easily held in the palm of your hand.